Readers ask: How To Install Cedar Shingle Siding Video?

Readers ask: How To Install Cedar Shingle Siding Video?

What do you put under cedar siding?

A vapor barrier is also recommended with cedar siding. The Dupont Tyvek DrainWrap is a quality barrier with built-in channels to channel away excess water. Regardless of new or remodeling installation, Dupont Tyvek DrainWrap weather-resistant barrier is recommended before installation of the cedar siding.

Where do you nail cedar shingles?

Place two nails 2 cm (3/4 in.) from each edge of the cedar shingle and 4 cm (1 1/2 in.) above the exposure. To avoid buckling, allow 3 to 6 mm (1/8 to 1/4 in.)

How much do you overlap cedar shingles?

Leave a gap of approximately 1/8” to 1/4” (0.3 to 0.6 cm) between neighboring shingles to allow for expansion due to moisture. Joints of successive courses must always be offset by at least 1 1/2” (3.8 cm) to prevent water build-up. Treat shingle imperfections the same way.

Do you need furring strips for cedar siding?

Cedar is a material that needs to be allowed to flex once installed. It is highly recommended that the product be installed over furring stripes that are attached to the studs of a wall. For siding that is being installed in a horizontal pattern, the furring strips should be attached vertically.

You might be interested:  Quick Answer: How To Fill Holes In Siding?

What is the best underlayment for cedar siding?

The Cedar Shake and Shingle Bureau recommends installation over Type 30 asphalt felt underlayment for red cedar shingles and shakes. Install the felt paper with minimum 6-inch overlaps on vertical joints, 2 inches on horizontal laps, and 4 inches wrapped each way at inside and outside corners.

What size nails do you use for cedar shingles?

Staples must be 16 gauge with crowns 7/16″ minimum horizontal, maximum 3/4″ horizontal to the Certi-label shake or shingle butt. Fasteners, two (2) per shake or shingle, shall be applied approximately 3/4″ from the edge and approximately 1 1/2″ above the exposure line.

What fasteners to use with cedar shingles?

Each Certi-label Western Cedar shingle or shake should be applied with two corrosion-resistant fasteners, such as stainless steel (type 304 or 316), hot-dipped zinc coated, or aluminum nails or other fastener as accepted by your local building official.

Can you staple cedar shingles?

The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water. For locations outside of the salt water zone – stainless steel staples Type 304 or Type 316 must be used.

How far do you space cedar shingles?

The split face is always installed to the weather, the sawn face to the deck. The starter course may be one or two layers of cedar shingles or shakes, overlaid with the desired shake. Spacing between adjacent shakes should be a minimum of 9mm and maximum of 16mm.

You might be interested:  Quick Answer: What Size Nails Do I Use For 4x8 T111 Siding?

How many nails are in a square of cedar shingles?

The standard required amount of nails for cedar shingles is 320 pieces per square. For areas with a lot of wind, six nails for each shingle might be needed, which means you need 480 nails for each square.

Can you buy vinyl siding by the piece?

Yes. Just make sure they are by the same manufacturer or at least will lock together at the horizontal connections. Best to take an actual sample piece of existing siding to your building supply so they can order the right product.


Leave a Reply

Your email address will not be published. Required fields are marked *