Quick Answer: What Nails Do You Use For Hardie Siding?

Quick Answer: What Nails Do You Use For Hardie Siding?

What nails do you use on hardiplank siding?

NAIL TYPE: Electro-galvanized nails are acceptable for use with James Hardie Siding Products, but may exhibit premature corrosion. James Hardie recommends the use of quality, hot-dipped galvanized nails.

Do you nail or screw Hardie board?

Fasten HardieBacker sheets with proper nails or screws (as listed in ”Materials Required” in the backer installation instructions) every 8” around the perimeter and all supporting studs. Keep fasteners between 3/8” and 3/4” from sheet edges and 2” in from sheet corners.

What length nails do you use for Hardie siding?

Pick out stainless steel or hot-dipped galvanized nails size 6d, 1 1/2-inch-long siding nails and 2-inch long siding nails in the quantity you need for your project.

Can you put a nail in Hardie board?

James Hardie recommends that nails be hot dip galvanized (at a minimum) or stainless steel (as a best practice). Anything less and the nails may start to rust, leading to stains on your beautiful siding.

Can you install hardiplank directly to studs?

HardiePlank ® lap siding can be installed over braced wood or steel studs spaced a maximum of 24″ o.c. or directly to minimum 7/16″ thick OSB sheathing.

You might be interested:  Question: How To Fix Hole In Siding?

Can I use a framing nailer for Hardie siding?

The answer is, yes. Framing nail guns can be used for siding installation, if the nail being used is long enough to attach the siding firmly to your exterior wood sheathing. You may also find that siding nailers are a few pounds lighter than framing guns.

How do you screw into hardiplank?

Drill pilot holes, at each mark, one-quarter to one-half inch deep, to make it easier to insert screws and prevent cracking the siding. Align the bracket holes with the pilot holes in the siding. Insert the screws and tighten securely using a drill with screwdriver bit attached. Hang the basket on the bracket.

How long can Hardie board go unpainted?

Pre-primed products can sit for 6 months without paint. Unprimed hardie can sit for 3 months without paint.

Can you use screws on Hardie board trim?

ET&F or equivalent fasteners or screws may be used to attach HardieTrim boards to steel frame construction. James Hardie recommends using stainless steel finish nails when installing HardieTrim products. Use a 2 in. finish nail to fasten trim together.

Does siding need to be nailed into studs?

Vinyl siding must never be applied directly to studs without sheathing. As an alternative, installation of specific types of drop-in contoured foam underlayments for various styles of vinyl siding are available.

How long is a 16d framing nail?

A 16d nail is one that is 3-1/2 inches long.

Is Hardie board siding waterproof?

Hardie siding is waterproof, fire resistant, and pest and insect resistant, which means that not only will the siding last, but it will protect the interior of your home for longer, without warping or breaking.


Leave a Reply

Your email address will not be published. Required fields are marked *