Quick Answer: What Is The Best Way To Cut Vinyl Siding?

Quick Answer: What Is The Best Way To Cut Vinyl Siding?

What is the best tool to use to cut vinyl siding?

A utility knife is typically the best tool for cutting vinyl siding when you’re making longitudinal cuts along the length of a plank. If you’re only making a few vertical cuts, it’s best to use tin snips or a hand saw.

How do you cut vinyl siding on a house?

Utility Knife

  1. Place a strip of siding face-up on the work table. Place a straightedge lengthwise on the strip to mark where you plan to cut it.
  2. Score along the straightedge with a utility knife. Use medium pressure.
  3. Bend the strip of siding along the cut and snap the vinyl.

Can you cut vinyl siding with a utility knife?

A plain old utility knife is the best tool for making longitudinal cuts along the length of a vinyl siding plank. You can score the material and break it in much the same way you cut drywall, but because vinyl is less forgiving, you will have to measure and cut carefully.

You might be interested:  How To Install Vinyl Shake Siding?

Can you cut vinyl siding with a hacksaw?

Install a 32 TPI hacksaw blade into a hacksaw frame. This fine-toothed hacksaw blade will cut through vinyl if you are going to be using a manual saw. Sand any rough edges with 220-grit sandpaper when you are finished.

What tools are needed to install vinyl siding?

Basic Installation Tools and Equipment

  • Power Saw. A bench or radial-arm power saw can speed the cutting of the siding or soffit.
  • Utility Knife. Vinyl is easy to cut, trim, and score with a utility knife or scoring tool (Fig.
  • Tin Snips.

Do I need house wrap behind vinyl siding?

There is no logical reason not to have house wrap under vinyl siding, and many authorities strongly agree that it should be viewed as mandatory, even if your local building codes don’t necessarily require it. Another benefit of quality vinyl siding is that it is highly water-resistant when correctly installed.

How much does it cost to side a 1500 sq ft house?

Aluminum siding costs An average 1,500 square foot house would cost around $7,700 for standard aluminum siding and upwards of $11,000 for custom grades after labor and material costs.

How do you cut vinyl siding on a door?

Score the flat sections of the siding panels with a sharp utility knife, following the pencil lines that you traced for the perimeter of the new door. Drag the knife along the pencil lines several times until you cut through the vinyl.

What type of saw blade cuts vinyl?

Vinyl fencing can be cut just like wood. Preferably use a circular saw with a PVC blade or a sharp and straight fine-tooth carbide blade. If your saw blade is designed for rough cutting lumber and dull, it could shatter the vinyl.

You might be interested:  Quick Answer: What Makes Vinel Siding Shine?

Why do you need to leave a ¼ expansion joint when installing vinyl siding?

Allow for Expansion and Contraction Vinyl siding installation must allow for material expansion and contraction caused by weather. Cut your siding in lengths with a 1/4 -inch gap for expansion wherever siding butts accessories.

How do you cut cold vinyl siding?

If you have to rip down some vinyl siding, you can just use a sharp utility knife and a straight edge. Slice along the straight edge, then just bend the siding, and it will snap clean.


Leave a Reply

Your email address will not be published. Required fields are marked *