How To Install Cedar Shingles Siding?

How To Install Cedar Shingles Siding?

What do I put under cedar shingles?

The Cedar Shake and Shingle Bureau recommends installation over Type 30 asphalt felt underlayment for red cedar shingles and shakes. Install the felt paper with minimum 6-inch overlaps on vertical joints, 2 inches on horizontal laps, and 4 inches wrapped each way at inside and outside corners.

Where do you nail cedar shingles?

Place two nails 2 cm (3/4 in.) from each edge of the cedar shingle and 4 cm (1 1/2 in.) above the exposure. To avoid buckling, allow 3 to 6 mm (1/8 to 1/4 in.)

How much do you overlap cedar shingles?

Leave a gap of approximately 1/8” to 1/4” (0.3 to 0.6 cm) between neighboring shingles to allow for expansion due to moisture. Joints of successive courses must always be offset by at least 1 1/2” (3.8 cm) to prevent water build-up. Treat shingle imperfections the same way.

Which side of cedar shingle faces out?

Are cedar shingles one sided, and if so, which side faces out? Cedar shingles have 2 ( faces ) sides and the best looking face is installed exposed to the weather. The face you like best is the one that should be installed exposed to the weather.

You might be interested:  Readers ask: How To Remove Concrete Splatter From Vinyl Siding?

Are cedar shingles waterproof?

Are cedar shingles waterproof? Cedar wood shingles are prone to mold, mildew, and insects. It is important to note that the wood on a cedar roof is not intended to be waterproof, and is therefore quite susceptible to wind-driven rain. Any natural product exposed to water is vulnerable to mold, mildew and erosion.

What type of nails should I use for cedar siding?

Hot-Dipped galvanized, aluminum and stainless steel nails are all corrosion-resistant and all can be used to nail Western Red Cedar. Other types of nails are not recommended. They can rust and disintegrate and react adversely with the natural preservative oils present in cedar resulting in stains and streaks.

What size nails do you use for cedar shingles?

Staples must be 16 gauge with crowns 7/16″ minimum horizontal, maximum 3/4″ horizontal to the Certi-label shake or shingle butt. Fasteners, two (2) per shake or shingle, shall be applied approximately 3/4″ from the edge and approximately 1 1/2″ above the exposure line.

Can you staple cedar siding?

The Cedar Shake & Shingle Bureau prefers the use of nails, however if you choose to use staples they must be stainless steel Type 316 in locations within fifteen (15) miles of salt water. For locations outside of the salt water zone – stainless steel staples Type 304 or Type 316 must be used.

What is the purpose of cedar breather?

Cedar Breather ® protects the beauty and life of wood roofing by providing a space for continuous airflow between the solid roof deck and shingles or shakes.

You might be interested:  Question: How To Install Exterior Window Trim On Vinyl Siding?

How far do you space cedar shingles?

The split face is always installed to the weather, the sawn face to the deck. The starter course may be one or two layers of cedar shingles or shakes, overlaid with the desired shake. Spacing between adjacent shakes should be a minimum of 9mm and maximum of 16mm.

What is the difference between wood shingles and wood shakes?

Cedar shakes are split off while shingles are sawn smooth on both sides and cut tapered. Lastly, shakes are thicker than shingles. Durability – Generally speaking, cedar shakes are more durable and last longer than shingles because they are thicker and made from premium grade wood.

Can cedar shingles be left untreated?

Rot – Because the shingles are left untreated, they are exposed to water and can rot overtime. What happens is the roof shingles will get wet when it rains, and if the shingles touch the cedar, the cedar will absorb the water, which will eventually lead to rot. Leaving more of a gap will allow the shingles to dry.

How long does cedar siding last?

How long can I expect my cedar siding to last? Cedar siding endures the elements well and if maintained properly can last many years. Some manufacturers offer warranties of 25 years or more. Cedar is classified as a durable species.

How do you keep cedar shingles looking new?

If you like the natural cedar siding look, you can apply a clear coat solution to them. This clear coat solution will help prolong the life of the wood and will slow down the weathering process to help preserve the natural unfinished look of cedar.


Leave a Reply

Your email address will not be published. Required fields are marked *