How To Cut Vinyl House Siding?

How To Cut Vinyl House Siding?

What is the best tool to cut vinyl siding?

A utility knife is typically the best tool for cutting vinyl siding when you’re making longitudinal cuts along the length of a plank. If you’re only making a few vertical cuts, it’s best to use tin snips or a hand saw.

Can you cut vinyl siding with a utility knife?

A plain old utility knife is the best tool for making longitudinal cuts along the length of a vinyl siding plank. You can score the material and break it in much the same way you cut drywall, but because vinyl is less forgiving, you will have to measure and cut carefully.

Can you cut vinyl siding with a hacksaw?

Install a 32 TPI hacksaw blade into a hacksaw frame. This fine-toothed hacksaw blade will cut through vinyl if you are going to be using a manual saw. Sand any rough edges with 220-grit sandpaper when you are finished.

What blade do you use to cut vinyl?

Vinyl fencing can be cut just like wood. Preferably use a circular saw with a PVC blade or a sharp and straight fine-tooth carbide blade. If your saw blade is designed for rough cutting lumber and dull, it could shatter the vinyl.

You might be interested:  FAQ: How To Install Hardie Lap Siding?

What tools are needed to install vinyl siding?

Basic Installation Tools and Equipment

  • Power Saw. A bench or radial-arm power saw can speed the cutting of the siding or soffit.
  • Utility Knife. Vinyl is easy to cut, trim, and score with a utility knife or scoring tool (Fig.
  • Tin Snips.

Why do you need to leave a ¼ expansion joint when installing vinyl siding?

Allow for Expansion and Contraction Vinyl siding installation must allow for material expansion and contraction caused by weather. Cut your siding in lengths with a 1/4 -inch gap for expansion wherever siding butts accessories.

How do you cut cold vinyl siding?

If you have to rip down some vinyl siding, you can just use a sharp utility knife and a straight edge. Slice along the straight edge, then just bend the siding, and it will snap clean.

How do you cut vinyl lattice?

Cut through the lattice joint by joint using a circular saw with a vinyl – cutting blade. If you don’t have a vinyl – cutting blade, you can use another fine-toothed blade. Ease the saw or blade carefully through the lattice. Proceed slowly to prevent chipping.


Leave a Reply

Your email address will not be published. Required fields are marked *