FAQ: How To Trim Cedar Siding Shingles On A Side Wall Where It Meets A Roof Line?

FAQ: How To Trim Cedar Siding Shingles On A Side Wall Where It Meets A Roof Line?

How do you trim cedar shingles?

Slice down the cut line with a sharp utility knife. This will create a small score line in the shingle surface. Gently work the two edges of the shingle back and forth until the shingle snaps along the scored cut line. If necessary, deepen the cut line with multiple passes from the utility knife.

Does flashing go under or over shingles?

Instead of installing the step flashing between shingles, the flashing rests on top of the shingles. It’s not unusual to see sealant installed when sidewall flashing is missing. Sealant will eventually dry, shrink and crack. You’ll see sealant substituted for flashing in a lot of different areas on roofs.

How much do you overlap cedar shingles?

Leave a gap of approximately 1/8” to 1/4” (0.3 to 0.6 cm) between neighboring shingles to allow for expansion due to moisture. Joints of successive courses must always be offset by at least 1 1/2” (3.8 cm) to prevent water build-up. Treat shingle imperfections the same way.

What do you put under cedar siding?

A vapor barrier is also recommended with cedar siding. The Dupont Tyvek DrainWrap is a quality barrier with built-in channels to channel away excess water. Regardless of new or remodeling installation, Dupont Tyvek DrainWrap weather-resistant barrier is recommended before installation of the cedar siding.

You might be interested:  Question: What Is The Cheapest Best Stain For Rough Lumber Old Siding?

What nails do you use for cedar shingles?

Ideal nails to use on cedar wood are made from aluminum, double-dipped galvanized, or stainless steel. Other types of nails such as plain steel nails are not advisable because reactions between the nails and the siding and the environment will create ugly stains on your siding over time.

Do you gap cedar shingles?

There are two typical ways to finish the top of a wall. a. The first way is to install molding to the wall and butt the shingles to it, remembering that the final course needs to have a minimum of a 4” exposure. Leave a ½” gap between the molding and the soffit for air flow.

How do you hang cedar siding?

Bevel siding should be face nailed to studs with 1-1/4 inch penetration into solid wood using one nail per piece spaced at a maximum of 24 inches on center. Place nail just above the overlap. Take care not to nail through the overlap of two pieces.

How much is a bundle of cedar shingles?

Comparing Per Square & Bundle Prices of Shakes

Type Per Square Per Bundle
Cedar $400 $130
Wood $350 $120
Composite $325 $110

How long do cedar shingles last?

But how long will your cedar shake roof actually last? As long as it’s properly installed and with proper maintenance, you can expect to get 30 years of life out of your cedar shake roof. If you invest in quality materials and live in an area with the right conditions, you could possibly get up to 50 years out of it.

You might be interested:  How To Cut Plywood Siding For Gable Ends?

How much does it cost to cedar shingle a house?

The average cost to install cedar shingle siding ranges from $6 to $15 per square foot. You can expect to pay between $10,200 and $24,600 for a licensed contractor to install new cedar shingle siding on a typical house. This includes the cost of having a contractor remove the existing siding.


Leave a Reply

Your email address will not be published. Required fields are marked *