FAQ: How To Install Hardiplank Siding?

FAQ: How To Install Hardiplank Siding?

Can I install Hardie siding myself?

Fiberboard cement siding can be hand-nailed, but because it’s so much harder and more brittle than wood, you have to predrill holes near any edge. You can save yourself a bunch of time by using a pneumatic coil siding nail gun.

How do you fasten Hardie board?

Fastening Siding Fiber cement siding can be nailed by hand or with a pneumatic nailer. It can also be attached using corrosion resistant screws. Use hot-dipped galvanized or stainless steel nails. Nails should penetrate through the sheathing and at least 1” into studs.

Do you need plywood behind Hardie board?

Fiber cement siding should be installed over plywood, OSB, or sheathing. Be sure that the siding installed is dry. Building codes will usually require installing siding over water-resistant barriers and nailed into the studs every 16 or 24 inches.

What nails do you use for Hardie siding?

NAIL TYPE: Fasteners must be corrosion resistant, galvanized or stainless steel. Electro-galvanized nails are acceptable for use with James Hardie Siding Products, but may exhibit premature corrosion. James Hardie recommends the use of quality, hot-dipped galvanized nails.

You might be interested:  What Type Of Paint To Use On Exterior Siding?

Can you install Hardie siding directly to studs?

HardiePlank® lap siding can be installed over braced wood or steel studs spaced a maximum of 24″ o.c. or directly to minimum 7/16″ thick OSB sheathing. See General Fastening Requirements.

Can you screw into Hardie board siding?

Can you screw James Hardie siding? If you mean “ can you put screws into James Hardie siding ” the answer is yes. Otherwise, you may have landed on the wrong website. James Hardie boards can technically be drilled like wood, but it is best to use a masonry bit to drill this tough fiber-cement board.

Does Hardie board crack?

Because Hardie siding is so stiff any movement of the house can cause cracks in the siding which are typical of any rigid masonry product.

Do you nail or screw Hardie board?

Fasten HardieBacker sheets with proper nails or screws (as listed in ”Materials Required” in the backer installation instructions) every 8” around the perimeter and all supporting studs. Keep fasteners between 3/8” and 3/4” from sheet edges and 2” in from sheet corners.

Does Hardie board need to be painted?

What is Hardie Plank? Hardie Plank is a newer composite material made of concrete substrate. Hardie Plank is also called fiber cement siding. While it’s far heavier than aluminum, vinyl or wood, it is extremely durable and typically only needs a new paint every ten to twenty years for maintenance.

Do termites eat Hardie board?

Do Termites Eat Hardie Board? Although termites do eat wood, they cannot get to the wood in Hardie Board siding because of the fiber cement materials throughout the product.

You might be interested:  Question: What Do You Call The Rust Colored Water Stain On Siding?

Does Hardie board need a vapor barrier?

Hardibacker doesn’t need a vapor barrier or waterproofing except you do need to tape and thinset the joints.

Do I need house wrap behind Hardie siding?

With fiber cement siding, the heavy material may compress the wrap so it’s extremely important that a non-woven wrap is used. This is because the heavy siding may lead to a build-up of moisture behind it, which in turn, can lead to mold growth and wood rot if that moisture is not properly addressed.

Does siding need to be nailed into studs?

Vinyl siding must never be applied directly to studs without sheathing.


Leave a Reply

Your email address will not be published. Required fields are marked *